The collector car market, in your inbox
Classic car news, hand-picked vehicles, and auction coverage. Choose what lands in your inbox.
BMW's E9 coupe is already one of the best-looking cars of the 1970s, so swapping out its engine takes some nerve. The owner of this Inka Orange 1974 BMW 3.0 CSi, live at no reserve on Cars & Bids, did it anyway. The car now runs a 3.5-liter S38 stroker straight-six built by VAC Motorsports, and the auction closes November 20 at 1:36 p.m. ET. The high bid was $37,007 across nine bids when we checked.
An M-Car Six in an E9
The S38 is the high-strung inline-six BMW's Motorsport division built for its M5 sedans, and the E9 never got one from the factory. According to the seller, this coupe's original drivetrain is gone. In its place is a VAC Motorsports stroker with a 97-millimeter crankshaft, forged CP pistons, Arrow connecting rods and CAT cams, running 10.5:1 compression. VAC also reworked the cylinder head to its Stage 3 spec and supplied a 48-millimeter throttle-body conversion, and a Hartge carbon-fiber plenum sits on top. The intake piping is routed low through the Alpina-style front air dam, and Remus handles the exhaust.
The seller lists no horsepower figure, which is refreshing. The story here is the engineering, not a dyno number.
The Rest of the Drivetrain
Power goes to the rear wheels through a Precision Gearing close-ratio dogleg five-speed on an S38 bell housing, the sort of transmission that gives a track-day car its character. The differential is an E9 unit rebuilt with E30 internals by Pete's Gear Shop. A trunk-mounted fuel cell, SPAL cooling fans with a variable-speed controller, and an upgraded oil pump round out the mechanical work.
The chassis isn't an afterthought. The seller reports factory BMW CSL chassis reinforcements, Koni rear shocks, ST sway bars and Wilwood front calipers. The car rides on 17-inch HRE modular wheels, with rolled front arches, widened rear arches and French-style yellow headlights. Inside, it has Sebring leather, heated CSL-style front seats and an Alcantara-wrapped aftermarket wheel. The seller says the car was restored and repainted as part of the build, and that service records going back to 2010 are in the gallery.
What the Build Story Says
A comment from Dave Grisel, who identifies himself as the owner of Ottowerks and says he worked on the car's design and engineering, adds detail that isn't in the seller's equipment list. He says a specialist named Franz hand-built the engine-bay harness with aerospace-style connectors and installed and calibrated a Life Racing engine-management system. He also says the rear crossmember and semi-trailing arms are adjustable for toe and camber. Treat that as a commenter's account rather than documented fact, and ask the seller to confirm it.
What to Know Before Bidding
The seller is open about the flaws. The car reportedly bogs around 2,600 rpm because the ignition timing is set aggressively while the new engine breaks in, and the wipers and the air-fuel ratio calibrator don't work. The fuel gauge is intermittent, and it can leak a couple of drops of oil after sitting for a few days. Paint chips, misaligned trim on the driver's door and some wear in the interior are also noted. Ottowerks' comment says the hesitation fades as the engine warms and should be fixable with a calibration.
The odometer shows 1,000 miles on a five-digit unit, the title is clean (California), and the car is in San Diego. The seller is representing the owner, who reportedly bought it in January 2011. If you've been following the restomod boom, this is the old-school version: a hand-assembled, motorsport-flavored engine in a car that already looked the part. It's also a different flavor of BMW swap than the 850Ci that traded its automatic for an E46 M3 six-speed, and a more serious one than most 1970s BMW offerings you'll see this month.
Photos and details are on the original listing; bids are placed with Cars & Bids, which adds a buyer's fee on top of the final price.
Listing: 1974 BMW 3.0 CSi on Cars & Bids